Where to get belt cut

There's always going to be extra room because of the shape of our shoe lasts. There is enough room across the widest part of your foot and your heel sits comfortably in the shoe. If you can confidently strut your stuff in the shoes, you're good to go. And don't worry about minor heel slippage or extra room in the your toes! After you break in your new shoes, the heel slippage will stop.

Our Italian calfskin leather needs a chance to conform to your foot. If it doesn't, email us and we'll make it right. Cut-To-Fit Belt Tutorial. Posted on Nov 02, Time to break out a pen and paper and get ready for some knowledge. Paul Evans exclusively carries cut-to-fit genuine Italian leather handmade belts from Naples. As the name implies, cut-to-fit belts require a manual cutting for a completely custom fit. If you own any off-the-rack belts that are just a tad too large or small because of the hole placement, you're going to love our cut-to-fit belts.

We recommend taking our belts to a professional shoe cobbler who will be able to measure and cut any belt in just a few minutes. Beltman, Inc. Our custom leather concealed carry gun belts don't stretch or sag and will take an amazing amount of abuse and still look good!

Proudly made in Clanton, Alabama. Menu Cart. Send the box to: Beltman, Inc. It's only very slightly more work. Calculate how much shorter the belt needs to be by wrapping it around your waist where you like to wear it, and measuring from the hole you want to use to the bar the tongue is attached to. In this technique, you will overlap the cut ends by about half an inch or more if you want , so subtract this amount from the measured distance to get the actual length to remove.

Cut the belt near the buckle, making sure to leave a half inch or so of the single layer of belt material after the folded over part see pic. Cut the body of the belt again, your calculated distance from the cut end. You now have three belt pieces: the buckle piece, the too-long piece discard this , and the tail end. The buckle and tail pieces together are about half an inch longer than you want the belt to be. Sewing works for most belts, but if you have rivets available to you, that is also appropriate for any belt that is not too light-weight.

Place the cut end of the body under the cut end of the buckle piece, butted up against the end of the fold-over, as tightly as possible.